Building Construction Set-3

5

Building Construction Set-3

1 / 25

The depth of the concrete bed of the foundation depends upon 

2 / 25

The entrained concrete is used in lining walls and roofs for making

3 / 25

In grillage foundations, distance between flanges of grillage beams, is kept 

4 / 25

The size of a floor tile commonly used, is 

5 / 25

The important test to be conducted on a stone used in docks and harbours is 

6 / 25

The piece of a brick cut with its one corner equivalent to half the length and half the width of a full
brick, is known as 

7 / 25

The type of bond in a brick masonry containing alternate courses of stretchers and headers, is
called

8 / 25

Vertical construction joints are provided where the shearing forces are minimum in the case of 

9 / 25

The vertical distance between the springing line and the highest point of the inner curve of an arch is
known as 

10 / 25

The width of the hollow space between two walls of a cavity wall should not exceed 

11 / 25

The predominant constituent which is responsible for strength in granite is 

12 / 25

A covering of concrete placed on the exposed top of an external wall is known as

13 / 25

Single Flemish bond consists of 

14 / 25

The member which is placed horizontally to support the common rafter of a sloping roof, is 

15 / 25

To ensure that supporting area of an offset footing of a boundary wall is fully compressive, the
C.G. of load must act

16 / 25

The foundations are placed below ground level, to increase 

17 / 25

A pre-stressed concrete pile is

18 / 25

For effective drainage, the finished surface of flat roof should have a minimum slope of 

19 / 25

The type of joint commonly used at the junction of a principal rafter and tie beam in timber
trusses is

20 / 25

During percussion drilling 

21 / 25

In a colar beam roof

22 / 25

A wooden block fixed on back side of a door frame on its post, is known as

23 / 25

The sill of a common wooden partition is 

24 / 25

The type of stone masonry in which stones of the same height are laid in layers is called 

25 / 25

The bond in which headers and stretchers are laid in alternate courses and every stretcher course
is started with a three fourth brick bat, is known as

Your score is

The average score is 38%

0%